Integrated Digital Workflow Training for Assistive Technology Development
DOI:
https://doi.org/10.24076/swagati.2026v4i3.3015Keywords:
Digital Fabrication, Assistive Technology, 3D Scanning, 3D Printing, Prosthetic HandAbstract
People with disabilities continue to face barriers accessing inexpensive and specialized assistive technologies. Digital fabrication provides a viable solution by combining three-dimensional (3D) scanning, digital modeling, and additive manufacturing into a single workflow. This community service program aims to introduce an integrated digital workflow for assistive technology development, with prosthetic hand manufacture serving as the application environment. The training was held on January 26-27, 2026, at SMK TI Bali Global Badung in Bali, and included 11 participants. Activities included workflow presentation, equipment demonstration, guided 3D scanning, scan visualization, mesh-quality discussion, introduction to CAD-based model preparation and 3D printing, and post-training evaluation. Participants witnessed the transformation of a physical thing into a 3D digital model and investigated the elements that influence scan and production quality. Evaluation across 11 indicators revealed an overall mean score of 4.12, with 87.7% of evaluations falling between 4-5. The greatest results were obtained for clarity of objectives (4.55), clarity of agenda (4.45), instructor performance (4.36), and participant satisfaction (4.36). The program was well received, emphasizing the importance of deeper CAD practice, organized competency evaluation, prototype verification, and user-centered validation in future events
Downloads
Published
Issue
Section
License
Copyright (c) 2026 SWAGATI : Journal of Community Service

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

